Saving Preset on Page 2 causes MC6 to display Page 1 names

When on Page 2, saving presets G-L from the Web Editor or controller edit mode has the appearance of returning the controller to preset Page 1. When you select presets on this page, you are actually selecting presets on page two, but the MC6 is displaying the Page 1 preset names. I haven’t checked if this occurred in the 2.4.2 release.  Here is the recipe:

1. Connect the MC6 to the Preset Manager.

2. Load the attached bank file. NOTE: This is a bank I’m working on to control a Voodoo Labs Hex. Page 1 sends CC toggles for turning each loop On / Off, and Page 2 sends PC messages to recall a preset of every loops On / Off state. On Preset’s B and H, there is a conditional type to toggle page if held for > 600ms.

3. Quit the Preset Manager and launch the Web Editor.

4. Toggle Editor Mode

5. Press and Hold (>600ms) Switch B to toggle to Preset Page 2.

6. Select Preset G by pressing Switch A. Observe that the Editor updates to show that you are editing Preset G.

7. Click Save from the Web Editor.

Result: Preset G is saved, however, the MC6 now displays the Preset Names on Page 1. The really bad part of this is that the MC6 is not actually on Page 1. Selecting another preset in this state will load a preset from Page 2 (you can see this in the Web Editor or MIDI monitor). If you press and hold Switch B (still preset H) to toggle page, you’ll see the MC6 blink, but the Preset Names from Page 1 persist; now the controller is in a correct state on Page 1.

https://drive.google.com/file/d/0B1IXvBhurLeJYkZBQXFrUXREeE0/view?usp=sharing