Toggle Preset

Technical support is needed to those websites that are totally nee and do not have ideas. About using the topics like essayhave review you will be able to collect the options for some important aspects.

Got it

Hi James,

Some how a page in the editor came up for just the expression pedal.

Not sure how I pulled it up. can you tell me how to get to it again.

To confirm the # entered in the value field would be the setting for the knob. the field N1 N2 is the CC which I believe is 14 for mix on the strymon.

Are there any setting that need to be enabled on the Strymon?

I am sorry to be a bother if there is some documentation you could point me to other than the manual which does not seem to give much detail.

Thanks,

-Steve

Hi Steve,

You just need to set the Val1 and Val2 values to be at 25% and 50% respectively. Then for the full range of the expression, the MC6 will send CC messages between these 2 values.

James thanks again for helping with my last question.

Can you walk me though setting up an expression pedal with Strymon time line.

Would like to control the mix and understand how to set the pedal to control a specific range of the mx knob.

eg. heel is at 25% mix toe is at 50% mix.

Would like to use the editor.

Thanks in advance.

Thank you!! Works great!!!

Hi Steve,

To toggle between bypass and active on the Bigsky, use a CC Toggle message. Take a look at the big sky manual, it states CC#102 to control bypass. Value 0 to bypass and 127 to engage. Use those values after you select the CC Toggle message in the editor.