I want to be able to set the toggle state of presets in other banks. For reference, I'm running the Morningstar MC6 MKII and Axe FX MKII both in the latest firmware. My first bank is preset selection in the AXE FX and Tempo/Tuner control. The second bank individually controls certain effects in my AXE FX patches (reverb, delay bypass, etc). Regardless of how many effects I add in the second bank, when I click on one of the patches in my first bank, it goes back to the patch as I've programmed it (e.g. clean with one reverb and no delay). BUT - the second bank still shows the toggle state for those effects as active (i.e. Pos 1), meaning I have to click them twice to add them again onto my fresh patch. I know there is a way to set the toggle state in messages for presets within the same bank. I would like to be able to set the toggle state to inactive (i.e Pos 2) for all the individual effects in my second bank when I activate a patch change in my first bank.
Is there a solution / work around for this? I have not been able to find a similar issue anywhere on this forum. Let me know if anything needs clarification,
Thanks for reading,
Jordan Robinson
Thanks for the reply, I'm using the Stomp to change presets not the MC6.
I have the same issue, when I switch between presets on my HX Stomp, it doesn't remember the state of the toggle switch. For example, if I'm switching from a preset where delay is 'on' to a preset where delay is "off" it still shows the delay as "off". I have to toe tap twice to get the delay on.
There must be a way to send patch messages to the MC6?
Thanks for the suggestion dude. I tried this out and it works flawlessly.
No can do. Are you using both pages (A-F, G-L)? If not, you can use ’Toggle Page’ to switch pages and ‘Set Toggle‘ will work for presets A-L. I typically use ‘Release’ as the primary action and have ‘Toggle Page’ on an action like ‘Long Press Release’. That way I can assign primary functions to all 12 presets and still be able to toggle between pages. If you want to have distinct functions on the same switch it is best not to use ‘Press’ as it will always activate.