I have tried this many times and it never works, the banks and switch is selected, toggle is on, Short name Off, Toggle On, Action: Press, Type: Control Change, cc:11, cc value 127 for pos 1, cc:11, cc value 0 for pos 2. When I save preset is where it says saving (forever) and the MKII says it's receiving data forever. Then after about three minutes it says data transfer failed. Does anyone know if I'm doing anything wrong or has had this same problem? I just took it out of the box and started after reading the manual and watching vids, thanks for any suggestions. Bryan
top of page
To test this feature, visit your live site.
Morningstar MKII v3.3.1 fails when saving block changes to HX Stomp
Morningstar MKII v3.3.1 fails when saving block changes to HX Stomp
1 comment
Like
1 Comment
bottom of page
I have had it happen on rare occasion. I’m pretty sure it’s USB related. So some suggestions. Recycle power on the MC6 and try again. Recycle power on your computer and try again. Don’t use a USB hub, go direct. A lot of devices are sensitive to which USB port on the computer is being used so you may need to test to see which ones work. I have read that when using a desktop computer it is best to use the ports on the back of the machine. Use a different USB cable. Tedious process but hope it helps.