I am using the MC6 I with my HX Stomp. I use the MC6 to control blocks on the stomp, when I change patches however, the MC6 of course does not change status to reflect the block conditions in the patch. For example, I have a button on the MC6 that toggles my effects loop on the stomp. When I change to a patch that has the effects loop active, the button on the stomp stays in whichever state it was in and may or may not display Effects loop is active, so it can take two button presses sometimes to switch the loop off. I expect I can set the button state with a midi signal from the stomp when I change to the patch that has the effects loop enabled, 808 engaged etc... Can someone direct me to the solution?
top of page
To test this feature, visit your live site.
MC6 button status changes via midi in
MC6 button status changes via midi in
3 comments
Like
3 Comments
bottom of page
This article is really contains lot more information about This Topic. We have read your all the information some points uk assignment are also good and some usually are awesome. Great post I would like to thank you for the efforts you have ma