Hi,
I've built myself a little 2 button extension switch to bank up and down on the MC6. I've noticed that there is a scarily fine line between banking up one bank and scrolling through more than one bank. Is there any way to set this up so that it's harder to go further than 1 bank? Like can you make it so that you have to hold the switch for longer or even reduce those 2 switches sensitivity?
Secondly I noticed that when i hit one of the switches and then hit the other one while the MC6 is still displaying the bank then the second switch will continue scrolling in the direction that the first one was? For example if I hit the bank down switch and quickly then start pressing the bank up switch it will continue to bank down until the display clears. Is this something I have done wrong with my switch or is this normal for the MC6?
Please help.
Thanks!
I didn't find the right solution from the Internet.
References:
https://www.mornc6-bank-up-down
I'd recommend using the Bank Change Mode message type for now, which will bring you to a dedicated page to bank up and down on the MC6.
We'll fine-tune the bank change timings on the next firmware update. You can also add a delay message (under conditional message type) to slow down the bank changes.
For the scrolling bit, yes that is normal on the MC6.