Hi, I've got a question about use of Aux switches. I've been trying to set up switches to tap MC-6 bank-up and bank-down, but after one tap it hangs. Say if I'm using preset G and H for this purpose do I need to programme the same commands on all 30 banks,? That would seem a bit long-winded. Cheers,
top of page
To test this feature, visit your live site.
MC-6 Bank up/down using aux switch programming.
MC-6 Bank up/down using aux switch programming.
8 comments
Like
8 Comments
bottom of page
Basically, if there is nothing connected to the EXP inputs, you need to configure your inputs (from the main config menu) as EXP instead of AUX. If not you might notice that the MC6 is unresponsive in the main page.